Switch Plates

Bumpy · Postby **Bumpy** » Fri Jan 12, 2007 9:34 pm

Hi There guys and gals

Once again I need some advice...

Where can I get a few switch plates (on - off) like the scratched ones bellow

I need about 8 of them

Thanks in advance

Postby **Griffin** » Fri Jan 26, 2007 10:29 am

The plates are sold with the switches so you will probably have to buy a set new switches if you need to replace them. I don't think they are very expensive.

Postby **Morph** » Fri Jan 26, 2007 11:21 am

Bumpy my old mate

a good mate of mine Ranger does CNC cutting and could do it for you. Alternatively he could even recut your whole dash and engrave the on/off into the dash, much neater and very beautiful

email me pics and I'll ask him to give a quote

Slow_Poke · Postby **Slow_Poke** » Fri Jan 26, 2007 12:34 pm

Morph, will he be able to make me a panel for a std aquilla pod (not the large pod) in the same style as in the pic? but only with a cutout for a stratomaster extreme?

Postby **Morph** » Fri Jan 26, 2007 2:28 pm

Yes,

any style faceplate. If you trace it out on card-board and specify where you want what he can cut and engrave it.

He can even do multiple colours. Say you want red with black writing etc he has this multilayer coloured vinyl material that he sticks on top of the aluminium. The top layer will be red and the bottom will be black. The CNC machine will cut down through the top layer to expose the bottom just for the writing. So you will have all your red top surface with black engraved writing that will never wear out.

His name is Ranger on this forum

Bumpy · Postby **Bumpy** » Mon Jan 29, 2007 11:18 am

Hi Morph

Thanks for the advice; I sure wish I knew about it before I had all the instruments fitted!

I did however manage to find some inexpensive switches with the backing plates and will fit them this weekend.

Regards

Bumpy

RV4ker (RIP) · Postby **RV4ker (RIP)** » Wed Jan 31, 2007 10:11 pm

Morphman
I am awaiting delivery of new enigma for the Meercat. Need a new panel cut. Any contacts in Jhb. Guys I used before are no longer "interested". I used to email thm a DXF file and they send me the panel, but seems no

Postby **Morph** » Fri Feb 02, 2007 9:14 am

Unfortunately not,

I spoke to Ranger and he is happy to cut it for you from the DXF file. I'll pm you his email address. Call him on 0 ate 2, ate 9 three, five 3 seven 8

RV4ker (RIP) · Postby **RV4ker (RIP)** » Fri Feb 02, 2007 1:13 pm

Ta. Will drop him a line ASAP when I have rec'd the Enigma to confirm final dimentions...

Switch Plates

Switch Plates

Who is online