Microlighters

Hello Guys,

I need to replace the Rotary Valve hoses that goes to the small oil tank reservoir. One of them has a crack and eaven that is no leaking, I want to replace both.

One RV hose run on the back of the magnetos plate and I have to remove that plate/bracket in order to have access to the clamp were is attached.

That plate/bracket is attached to the engine by four screws............ Two of does upper screws also hold the water outlet socket in his place so I will be carefull when removing does 2 screws.

So here are the questions:

Do the 2 remaining lower plate/bracket screws hold something else that the Magnetos plate? Or I just go ahead and remove them.

Any advise on doing this work? Do I need to remove something else to have access to that clamp/hose?

BTW, this Rotax 582 is a grey head, is top mounted on a Quicksilver UL and the spark plugs are facing up.

Thx for your time and help,

Isaac

Here is a pic of the Magnetos Plate (red arrow)

Hi

I found that I could get to that hose clamp with a screwdriver between the plate and the engine and was able to replace the hose without taking the plate off. If your clamp is positioned differently then this may not work - in this case I have attached the relevant page from the repair manual that I hope will answer your question - is posted as an attachment because I don't know how to inclue it in the body of the reply as you did with your picture. Please let me into the secret for future postings