Page 1 of 1
alt change from inches to milibars
Posted: Tue Apr 24, 2007 4:44 pm
by Gadget
Hi. can an alti be changed, migrated, morphed or forced from a inches scale to a millibar scale and if so, where can it be done and how expensive is it. it's either tht or I have to buy a new one at nearly 1800 rand. thanks.
Re: alt change from inches to milibars
Posted: Tue Apr 24, 2007 6:04 pm
by Mogas
Gadget wrote:Hi. can an alti be changed, migrated, morphed or forced from a inches scale to a millibar scale
Don't think that would be cost effective Gadget, I would print up a small conversion table and stick it nearby.
Posted: Tue Apr 24, 2007 6:13 pm
by cobra
Agreed, not a cheap "Gadget" to convert, if at all possible
Conversion table
http://www.pcwp.com/mb_conversion.html
Posted: Tue Apr 24, 2007 6:20 pm
by RV4ker (RIP)
Posted: Tue Apr 24, 2007 6:59 pm
by Gadget
Hi RV. Which aviation shop did you speak to? I spoke with aviation-engines and they said it would cost more than a new one and take about 4 weeks.
Posted: Tue Apr 24, 2007 7:22 pm
by RV4ker (RIP)
Posted: Wed Apr 25, 2007 9:00 am
by Morph
Gadget my mate
Call Aircraft Instruments 021 935 1702. They are in the Aviation Business Centre at CT intl. I bought a compass from them once and when I collected it from them I saw they had a full repair and calibration centre for all instruments. If anybody can do it they can. I figure it's just the little wheel that shows the inches that need to be replaced.
Posted: Wed Apr 25, 2007 11:47 am
by RV4ker (RIP)
Posted: Wed Apr 25, 2007 12:05 pm
by Morph
Posted: Wed Apr 25, 2007 12:14 pm
by Gadget
I spoke to them and the cost is about 850 to 900. the gentleman said the card is about 50 and the labour, two hours, is 800. still better than having to fork out 1800 for a new one. i will take it in during the next two weeks. thanks guys.
Posted: Wed Apr 25, 2007 12:55 pm
by RV4ker (RIP)