Page 1 of 1
Oil Cooler
Posted: Fri Mar 20, 2009 10:46 pm
by Old, Fat and Hairy
Any ideas about oil coolers for an Aerovee engine? Possibly something a little bigger than what's required for an 80hp donk in order to increase capacity and help with engine cooling. Do they need to be custom made or is there someone who can supply off the shelf models in various sizes and configurations? Anyone in SA who can supply in line filters?
Secondly, is one able to use the flexible armoured oil hose type lines for fuel lines? Any other suggestions?
Re: Oil Cooler
Posted: Fri Mar 20, 2009 11:09 pm
by justin.schoeman
Only used them for coolers for my car, but they have been mentioned a few times on this forum, and Avcom:
http://www.cirruscoolers.com/
They have a few standard coolers, or can custom make one to your requirements.
Re: Oil Cooler
Posted: Fri Mar 20, 2009 11:49 pm
by Old, Fat and Hairy
Shukran, effendi.
Will give them a go. How is your wee beastie coming along?
Re: Oil Cooler
Posted: Sat Mar 21, 2009 7:21 pm
by justin.schoeman
Old, Fat and Hairy wrote:Will give them a go. How is your wee beastie coming along?
Slow... Barely had a minute to work on it since I collected it. I will race you to finish
.
-justin
Re: Oil Cooler
Posted: Sun Mar 22, 2009 8:59 am
by Old, Fat and Hairy
In the same boat. Hardly home long enough to change my jocks before heading off again. Tempted to find someone to help me complete her while I'm away in exchange for a share.