Hi John, I dont regard myself as highly experienced at all.... but will share my opinion.
A fire on board (any aircraft) is for me right up there with a structural failure in terms of some of the worst things that could happen while flying!
Let me share some positive thinking... TRIKES DONT CATCH FIRE........EVER!!!
Jokes aside, there does seem to be very few cases where a fire has been reported "on board" (none I have ever heard of). There have been trikes that have burnt out on the ground post impact....but even this is rare.
I agree 100% with Dobbs....prevention is better than cure and ensuring all of the above, fuel lines, clamps, the tank itself etc are in good condition are great ways to prevent this. What is also of great importance is the electrical system. Make sure all electrical lines and wiring is free of oil residue and that the insulation is sound... If you do this, the chances of a fir on board is very very small.
Dobbs technique of turning off everything after one is discovered is exactly as I was taught. My instructor also taught me to descend as quickly as possible (increasing IAS) which could "blow out" the fire wherever it may be? If the fire is on the RHS of the engine...then try to make your decending turns in that direction as well....and vice versa. I think turning off the Mags should only be done once you are
sure you have a "landing ground" as a crash with an existing fire on board will be catastrophic anyway... That's what I was taught and I hope to
never have to use this part of my training.
I am also a little "anal" about oil on my engine. I clean it thouroughly after every flight so that there is no oil residue in any areas of concern. This also makes my Rotax look very nice
Anyway...like I said... TRIKES DONT CATCH FIRE!!!!
